Core Testing
Concrete core samples are extracted and tested to determine actual in-situ strength and structural quality.
Sampling & LabServices
Engineering services for existing & new structures.
A complete consultancy and testing capability — investigate, diagnose, design and supervise — backed by an ISO-certified laboratory.
01 · Consultancy
Existing Structures
Investigate, diagnose and rehabilitate ageing or distressed assets — from first condition survey to supervised repair.
- Consulting for restoration & rehabilitation
- Structural condition assessment
- Structural assessment & strengthening design
- Durability assessment (remaining service life)
- Repair design & specifications
- Repair supervision — QA & QC
02 · Consultancy
New Structures
Verify quality and design durability into new construction before defects become liabilities.
- Concrete evaluation for construction defects
- Durability planning
- Thermal modeling
- Cracking assessment
On-site & Laboratory Testing
Every test the diagnosis demands.
Non-destructive surveys, core sampling and load verification — performed to international standards on site and in the laboratory.
Non-destructiveUltrasonic Pulse Velocity (UPV)
Non-destructive test to detect internal cracks, voids and material uniformity within concrete.
On-site (NDT)
Non-destructiveRebound Hammer Test
Rapid, non-destructive estimate of surface hardness and compressive strength — ideal for uniformity and comparative analysis across a site.
On-site (NDT)Non-destructiveCrack Analysis
Assessment of cracks to identify type, cause and severity, informing the correct repair strategy.
On-site (NDT)
Non-destructiveWindow Opening Assessment
Checks the stability and condition of structural openings for alignment and safety.
On-site (NDT)
Depth of Carbonation
Determines the extent of chemical change in concrete from environmental exposure — critical for predicting reinforcement corrosion and planning maintenance.
Sampling & Lab
Non-destructiveHalf-Cell Potential Test
Measures the electrical potential of embedded steel to map corrosion risk and identify areas likely to corrode.
On-site (NDT)
Pull-Off Test
Measures the adhesion strength of coatings, plasters, paints and cementitious layers.
Load & CapacityLoad Test
Verifies the real performance of slabs, beams and structural elements under simulated or real loads — confirming design capacity and validating safety.
Load & Capacity
Pullout Test — Anchors, Rebars & Clamps
Determines the holding capacity of fasteners embedded in concrete or other substrates, ensuring the reliability of anchor bolts, rebar connections and façade fixings.
Load & CapacityStart with an assessment
Tell us about your structure.
Share the asset, the concern and your timeline. Our engineers will scope the right test programme and give you clear, costed options.